Supero SuperServer E200-8B, Руководство пользователя

Страница: 25 / 92

Chapter 2: Advanced Motherboard Setup
2-11
Front Control Panel
The pinouts of the JFI (control panel) connector are shown below. Only one of these
(those for the power button) are used on the E200-8B.
Figure 2-5. Control Panel Header Pins
Power Button
The Power Button connection is located
on pins 1 and 2 of JF1. Momentarily
contacting both pins will power on/off
the system. This button can also be
configured to function as a suspend
button (with a setting in the BIOS - see
Chapter 4). To turn off the power in the
suspend mode, press the button for at
least 4 seconds. Refer to the table on the
right for pin definitions.
Power Button
Pin Definitions (JF1)
Pin# Definition
1 Signal
2 +3V Standby
Power Button
OH/Fan Fail/PWR Fail/
LED Cathode
1
NIC1 Link LED
Reset Button
2
Power Fail LED
HDD LED
PWRLED
Reset
PWR
3.3 V
3.3V Stby
Ground
Ground
19 20
3.3V
X
Ground
X
NIC2 Link LED
3.3V Stby
3.3V Stby
X
DOM PWR Connector
The SATA Disk-On-Module (DOM) power
connector, located at JSD1, provides
power to a solid state DOM storage device
connected to one of the SATA ports. See
the table on the right for pin definitions.
DOM PWR
Pin Definitions
Pin# Definition
1 5V
2 Ground
3 Ground