Supero SuperServer 6036T-3R, Руководство пользователя

Страница: 40 / 102

5-8
S
UPER
S
ERVER 6036T-3R User's Manual
Memory Support
The X8DT3 supports up to 96 GB of DDR3 1333/1066/800 registered ECC SDRAM.
Three-way interleaved memory is supported: for optimal memory performance,
install DIMMs three at a time. See the following tables for memory installation.
DIMM Installation
Installing Memory Modules
Insert the desired number of DIMMs into the memory slots, beginning with 1.
DIMM #1A, DIMM #2A and DIMM #3A then DIMM #1B, DIMM #2B and DIMM
#3B. (see Memory Confi guration Table next page). Always spread DIMMs
across all three banks for each CPU (see Figure 5-4).
Insert each DIMM module vertically into its slot. Pay attention to the notch 2.
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
Gently press down on the DIMM module until it snaps into place in the slot. 3.
Repeat for all modules.
!
CAUTION! Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
5-6 Installing Memory
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Figure 5-3. DIMM Installation
Top View of DDR3 Slot
Release Tab
Release Tab
Note: Notch should align
with the receptive key
point on the slot.
Notch
Notch
Front View