Supero SuperServer 6036T-3R, Руководство пользователя

Страница: 21 / 102

Chapter 2: Server Installation
2-7
2-5 Checking the Serverboard Setup
After you install the 6036T-3R in the rack, you will need to open the unit to make sure
the serverboard is properly installed and all the connections have been made.
Accessing the Inside of the System (Figure 2-4)
Press the release tabs to remove the cover from the locked position. Press 1.
both tabs at the same time. If necessary, you may need to remove the chas-
sis cover screw.
Once the top cover is released from the locked position, slide the cover 2.
toward the rear of the chassis and lift the cover off the unit.
Checking the Components and Setup
You may have one or two processors already installed into the serverboard. 1.
Each processor needs its own heat sink. See Chapter 5 for instructions on
processor and heat sink installation.
Your 6036T-3R server system may have come with system memory already 2.
installed. Make sure all DIMMs are fully seated in their slots. For details on
adding system memory, refer to Chapter 5.
If desired, you can install add-on cards to the system. See Chapter 5 for 3.
details on installing PCI add-on cards.
Make sure all power and data cables are properly connected and not blocking 4.
the chassis airfl ow. Also make sure that no cables are positioned in front of
the fans. See Chapter 5 for details on cable connections.
!
Warning: Except for short periods of time, do NOT operate the server
without the cover in place. The chassis cover must be in place to allow
proper airfl ow and prevent overheating.