Supero SUPERSERVER 6017R-TDF, Руководство пользователя

Страница: 67 / 106

Chapter 6: Advanced Chassis Setup
6-9
6-5 Power Supply
The SuperServer 6017R-TDF has a single 440-480 watt power supply, which is
auto-switching capable. This enables it to automatically sense and operate at a
100v to 240v input voltage.
Power Supply Failure
If the power supply unit fails, the system will shut down and you will need to replace
the unit. Replacement units can be ordered directly from Supermicro. As there is only
one power supply unit in the 6017R-TDF, power must be completely removed from
the server before removing and replacing the power supply unit for whatever reason.
Removing/Replacing the Power Supply
1. First turn the power switch on the control panel off, then unplug the power
cord from the system.
2. Remove the chassis cover as described in Section 6-3).
3. After making a note of all wiring from the power supply to the motherboard,
disconnect them.
4. To remove the failed power supply, remove the two screws from the bottom of
the chassis that secure the power supply to the chassis.
5. Pull the power supply out of the chassis (see Figure 6-7).
Installing a New Power Supply
Replace the failed power supply with the exact same model (available from
Supermicro).
1. Carefully insert the new unit into the chassis.
2. Secure it through the bottom of the chassis with the two screws you removed
previously.
3. Reconnect the power cords that you disconnected when removing the power
supply.
4. Replace the top cover of the chassis.
5. Finish by depressing the power button on the chassis front control panel.