Supero SuperServer 5013C-MT, Руководство пользователя

Страница: 43 / 98

Chapter 5: Advanced Motherboard Setup
5-7
5-6 Installing Memory
1. Memory support
The P4SCT+ supports 4 GB of dual-channel, ECC or non-ECC unbuffered
DDR-400/333/266 SDRAM. You must populate both DIMM0A and DIMM1A
and/or DIMM0B and DIMM1B with the same size and type of memory
modules. This will result in dual channel (two-way interleaved) operation,
which is faster than single channel operation.
2. Installing memory modules
Insert each memory module vertically. Pay attention to the notch along the
bottom of the module to prevent inserting it incorrectly. Gently press down
on the DIMM module until it snaps into place in the slot (see Figure 5-5).
!
CAUTION! Exercise extreme care when installing or remov-
ing DIMM modules to prevent any possible damage.
Host Clock FSB (MHz)
(MHz)
100 400
133 533
200 800
DRAM Data Shown during
(MT/s) POST
266 DDR266
333 DDR266
400 DDR266
266 DDR266
333 DDR333
400 DDR333
266 DDR266
333 DDR320*
400 DDR400
Memory Speeds
* The BIOS displays DDR320 due to a chipset limitation.
To Install: Insert module vertically and press down until it snaps into place. Pay attention
to the bottom notch.
To Remove: Use your thumbs to gently push each release tab outward to free the DIMM from
the slot.
Figure 5-5. DIMM Installation