Supero SuperServer 5013C-MT, Руководство пользователя

Страница: 41 / 98

Chapter 5: Advanced Motherboard Setup
5-5
5-5 Installing Processors
Avoid placing direct pressure to the top of the processor
package. Always remove the power cord first before adding,
removing or changing any hardware components.
Processor Support
The P4SCT+ has a single 478-pin microPGA socket, which supports Intel
Pentium 4 processors on .013 micron process.
!
1. Lift the lever on the CPU socket.
2. Install the CPU in the socket. Make sure that
Pin 1 of the CPU is seated on Pin 1 of the socket
(both corners are marked with a triangle).
3. Press the lever down until
you hear it *click* into the
locked position.
4. Apply the proper amount of thermal com-
pound to the CPU die. Place the heatsink on
top of the CPU aligning its holes with those on
the retention mechanism. Screw in two diago-
nal screws (ie. the #1 and #2 screws) until just
snug, then do the same with the remaining two
screws. Finish by fully tightening all four
screws (see Figure 5-4 on next page).