Chapter 6: Advanced Chassis Setup
6-5
Figure 6-3. Removing the Dummy Drive from a Carrier
Installing a Drive
1. Remove the dummy drive, which comes pre-installed in the drive carrier, by
removing the screws securing the dummy drive to the carrier. These screws
are not used to mount the actual hard drive.
2. Insert a drive into the carrier with the PCB side facing down and the connector
end toward the rear of the carrier. Align the drive in the carrier so that the screw
holes of line up. Note that there are holes in the carrier marked “SATA” to aid
in correct installation.
3. Secure the drive to the carrier with four M3 screws as illustrated below. These
screws are included in the chassis accessory box.
4. Insert the drive carrier with the disk drive into its bay, keeping the carrier oriented
so that the hard drive is on the top of the carrier and the release button is on
the right side. When the carrier reaches the rear of the bay, the release handle
will retract.
5. Push the handle in until it clicks into its locked position
Содержание SUPERSERVER 1028U Series
