Supero Supero X7SB4, Руководство пользователя

Страница: 26 / 130

2-6
X7SB4/X7SBE User's Manual
2-4 Installing DDR2 Memory
Memory Module Installation
Exercise extreme care when installing or removing memory modules
to prevent any possible damage.
1. Insert each DDR2 memory module vertically into its slot. Pay attention to
the notch along the bottom of the module to prevent inserting the module
incorrectly. (See support information below.)
2. Gently press down on the memory module until it snaps into place.
Support
The X7SB4/X7SBE supports dual or single channel, ECC/Non-ECC unbuf-
fered DDR2 800/667 SDRAM. Both interleaved and non-interleaved memory
are supported, so you may populate any number of DIMM slots. (*Populating
DIMM#1A,DIMM#2A, and/or DIMM#1B, DIMM#2B with memory modules of
the same size and of the same type will result in two-way interleaved memory
which is faster than the single channel, non-interleaved memory. When ECC
memory is used, it may take 25-40 seconds for the VGA to display.)
Notes
Due to chipset limitation, 8GB Memory can only be supported by the following
operating systems:
32-Bit: Windows 2000 Advanced Server, Windows Server 2003 Enterprise
Edition;
64-Bit: Windows Server 2003 Standard x64 Edition, Windows XP Profes-
sional x64 Edition, Windows Server 2003 Enterprise x64 Edition
Some old-version of DDR2-667 may not match Intel's On-Die-Temperature
requirement and will automatically be down-graded to run @ 533 MHz, If this
occurs, contact your memory vendor to check the ODT value.
Due to memory allocation to system devices, memory remaining available
for operational use will be reduced when 4 GB of RAM is used. The reduction
in memory availability is disproportional. (Refer to the Memory Availability
Table below for details.)
•
•
•