Supero SUPER P6DGE, Руководство пользователя и BIOS

Страница: 80 / 98

BIOS User's Manual
5-20
On-Board Parallel Port
This option specifies the base I/O port address of the parallel port on the
motherboard. The settings are Auto (AMIBIOS automatically determines
the correct base I/O port address), Disabled, 378, 278 or 3BC.
Parallel Port Mode
This option specifies the parallel port mode. The settings are Normal, Bi-
Dir, EPP or ECP. When set to Normal, the normal parallel port mode is
used. Use Bi-Dir to support bidirectional transfers. Use EPP (Enhanced
Parallel Port) to provide asymmetric bidirectional data transfer driven by
the host device. Use ECP (Extended Capabilities Port) to achieve data
transfer rates of up to 2.5 Mbps. ECP uses the DMA protocol and
provides symmetric bidirectional communication. Note: The Optimal
default setting for this option is ECP and the Fail-Safe setting is
N o r m a l .
EPP Version
The settings are 1.7 or 1.9. Note: The Optimal and Fail-Safe default
settings are N/A.
Parallel Port IRQ
This option specifies the IRQ to be used by the parallel port. The settings
are Auto, 5 or 7.
Parallel Port DMA Channel
This option is only available if the setting of the parallel port mode option
is ECP. The settings are 0, 1, 2, 3, 5, 6 or 7. Note: This option is N/
A.
On-Board IDE
This option specifies the onboard IDE controller channels to be used. The
settings are Disabled, Primary, Secondary or Both.
5-2 Security Setup
5-2-1 Supervisor
User
The system can be configured so that all users must enter a password
every time the system boots or when the W INBIOS setup is executed.
You can set either a Supervisor password or a User password. If you
do not want to use a password, just press <Enter> when the password
prompt appears.