Supero SUPER P4SC8, Руководство пользователя

Страница: 44 / 96

3-2
S
UPER P4SC8/P4SCi User's Manual
NOTE:
If you are a system integrator, VAR or OEM, a POST
diagnostics card is recommended. For I/O port 80h codes,
refer to Appendix B.
Memory Errors
1. Make sure the DIMM modules are properly and fully installed.
2. You should be using unbuffered ECC/Non ECC DDR memory (see next
page). Also, it is recommended that you use the same memory
speed for all DIMMs in the system. See Section 2-4 for memory
limitations.
3. Check for bad DIMM modules or slots by swapping modules between
slots and noting the results.
4. Check the power supply voltage 115V/230V switch.
(*Note: The Intel 7210 Canterwood ES chip supports non-ECC or ECC
Unbuffered memory. If ECC memory is installed, the ECC bits need to be
initialized via BIOS before normal operation. For a 4 GB-Memory and 2.4-GHz
P4 system, it will take about 65 seconds for all the ECC bits to be initialized
before any video displays. Since ECC initialization takes time, the Watch Dog
Timer Select needs to be set to a time longer than what the ECC initialization
will take.)
Losing the System’s Setup Configuration
1. Make sure that you are using a high quality power supply. A poor
quality power supply may cause the system to lose CMOS setup
information. Refer to Section 1-6 for details on recommended power
supplies.
2. The battery on your motherboard may be old. Check to verify that it
still supplies ~3VDC. If it does not, replace it with a new one.
3. If the above steps do not fix the Setup Configuration problems, contact
your vendor for repair.
3-2 Technical Support Procedures
Before contacting Technical Support, please take the following steps. Also,
note that as a motherboard manufacturer, Supermicro does not sell directly
to end-users, so it is best to first check with your distributor or reseller for
troubleshooting services. They should know of any possible problem(s)
with the specific system configuration that was sold to you.
1. Please go through the ‘Troubleshooting Procedures’ and 'Frequently
Asked Questions' (FAQs) sections in this chapter or see the FAQs