Supero SUPER P3TSSA, Руководство пользователя

Страница: 32 / 105

2-4
S
UPER P3TSSA/P3TSSR/P3TSSE User’s Manual
Figure 2-2. Side View of DIMM Installation into Slot
N o t e : B o t to m
n o t c h e s s h o u ld
a lig n w it h th e
b u m p s o n t h e
s lo t
D IM M S lo t
D IM M
N o tc h e s N o tc h e s
2-4 Installing DIMMs
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
Note:
Check the Supermicro web site for recommended memory
modules:
http://www.supermicro.com/TECHSUPPORT/FAQs/Memory_vendors.htm
DIMM Installation (See Figure 2-2)
1. Insert DIMMs in Bank 0 through Bank 2 as required for the desired
system memory.
2. Insert each DIMM module vertically into its slot. Pay attention to the
two notches along the bottom of the module to prevent inserting the
DIMM incorrectly.
3. Gently press down on the DIMM module until it snaps into place.
4. If installing only a single DIMM, you may use any Bank. The P3TSSA/
P3TSSR/P3TSSE will support a total of 512 MB of unbuffered SDRAM
in its three DIMM slots. ECC type memory is not supported. PC133
and PC100 memory are both fully supported at their respective
speeds. However, if three DIMM modules are installed, the memory
will run at 100 MHz, even if PC133 memory is used (this is a chipset
limitation).
To Install:
Insert module
vertically and
press down
until it snaps
into place.
Pay attention
to the two
notches.