Supero Super 370SCD, Руководство пользователя и BIOS

Страница: 38 / 94

2-4
S
UPER PIIISCA/PIIISCD/PIIISCE/370SCD User's Manual
Installation
2-4 Installing RIMMs/DIMMs
CAUTION
Exercise extreme care when installing or removing RIMM/DIMM
modules to prevent any possible damage. Also note that
continuity modules must be installed into empty RIMM slots.
RIMM/DIMM Installation (See Figure 2-2)
1. Insert RIMMs/DIMMs as required for the desired system memory. See
note below for single module installation.
2. Insert each RIMM/DIMM module vertically into its slot. Pay attention to
the two notches along the bottom of the module to prevent inserting
the RIMM/DIMM module incorrectly.
3. Gently press down on the RIMM/DIMM module until it snaps into place in
the slot.
Note: Continuity modules must be installed in empty RIMM slots on the
PIIISCA/PIIISCE.
Note: Single module installation
If installing only a single DIMM, you may use either DIMM Bank 1 or 0.
If installing only a single RIMM module, it must be installed in the
RIMM slot nearest to the CPU slot and continuity modules must be installed
in all RIMM slots that remain empty.
Note: Changing memory types
When changing memory from SDRAM (DIMMs) to RDRAM (RIMMs) or vice
versa, you must first disconnect the AC Power cable and then use JBT1
to clear CMOS (see page 2-12).
2-3 Mounting the Motherboard in the Chassis
All motherboards have standard mounting holes to fit different types of
chassis. Chassis may include a variety of mounting fasteners made of
metal or plastic. Although a chassis may have both types, metal fasteners
are the most highly recommended because they ground the motherboard to
the chassis. For this reason, it is best to use as many metal fasteners as
possible.