Supero 2122TC-DL6RF4, Руководство пользователя

Страница: 25 / 118

Chapter 2: Server Installation
2-9
2-6 Checking the Serverboard Setup
After you install the 2122TC-DL6RF4 in the rack, open the unit to make sure the
serverboard is properly installed and all the connections have been made.
Before operating the system for the first time, it is important to remove the protective
film covering the top of the chassis, in order to allow for proper ventilation and
cooling.
Removing the Chassis Cover and Protective Film
1. Uplug the AC power cord from any external power source.
2. Remove the two screws which secure the top cover onto the chassis as
shown below.
3. Lift the top cover up and off the chassis.
4.
Peel off the protective film covering the top cover and the top of the chassis
5. Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
6. Replace the chassis cover and reconnect the AC power cord.
Figure 2-7. Accessing the Inside of the System
Remove two screws
Check Ventilation
Openings
1
2
1
3
1
4
1
1
Caution: Except for short periods of time, do not operate the server without the
cover in place. The chassis cover must be in place to allow proper airflow and
prevent overheating.