Supero 2022TC-BIBQRF, Руководство пользователя

Страница: 87 / 121

Chapter 6: Advanced Chassis Setup
6-9
6-6 Installing the Serverboard
I/O Shield
The I/O shield holds the serverboard ports in place. It does not require installation.
Figure 6-10. I/O Shield Placement
I/O Shields
Permanent and Optional Standoffs
Standoffs prevent short circuits by securing space between the serverboard and
the chassis surface. The SC827 chassis includes permanent standoffs in locations
used by the serverboards. These standoffs accept the rounded Phillips head screws
included in the SC827 accessories packaging.
Some serverboards require additional screws for heatsinks, general components or
non-standard security. Optional standoffs are used for these serverboards. To use
an optional standoff, place a hexagon screw through the bottom the chassis and
secure the screw with the hexagonal nut (rounded side up).
Depending upon the configuration of the serverboard being used, it is also possible
that some of the optional standoffs which are pre-installed in the chassis, may need
to be removed.
Installing the Serverboard (Figure 6-11)
1. Review the documentation that came with your serverboard. Become
familiar with component placement, requirements, precautions, and cable
connections.
2. Disconnect the power cord from any power source.
3. Pull the serverboard drawer out of the back of the chassis.
4. Remove the riser card brackets by removing the screw securing the bracket
to the back of the drawer. Lift the brackets out of the drawer.
5. Make sure that the I/O ports on the serverboard align properly with their
respective holes in the I/O shield at the back of the drawer.
6. Lay the serverboard in the drawer, aligning the standoffs with the serverboard.