Supermicro SuperWorkstation 5038A-I, Руководство пользователя

Страница: 45 / 84

Chapter 6: Advanced Chassis Setup
6-11 6-10
S
uper
W
orkstation 5038A-I User's Manual
9. Insert the hard drive carrier into the hard drive cage, sliding it towards the
back of the the hard drive cage until it clicks into a locked position.
10. If desired, each hard drive carrier may be secured to the exterior of the hard
drive cage using one optional screw.
11. Rotate the hard drive cage 90 degrees inward, returning it to the closed,
operational position in the chassis.
12. Connect the related cables to the hard drives.
Figure 6-8. Installing the Hard Drive Carrier into the Hard Drive Cage
1
11
1
9
Optional
Screw
Figure 6-9. Removing the 2.5" Hard Drives
1
4
1
5
Thumb Screw
6-7 Removing and Installing Optional 2.5" Hard Drives
The 5038A-I must be powered-down before hard drives can be removed.
Removing and Installing 2.5" Hard Drives
1. Disconnect the chassis from any power source.
2. Loosen the thumb screw securing the 2.5" hard drive cage to the chassis.
3. Disconnect all cables from the hard drive.
4. Slide the 2.5" hard drive cage out of the chassis.
5. If a hard drive is already present, remove it by carefully pulling the sides of
the hard drive carrier outward.