50
Chapter 3: Maintenance and Component Installation
Figure 3-10. Installing a 2.5" Drive into a Carrier
2.5" Drive
Installing a 2.5" Drive
1. Remove the dummy drive, which comes pre-installed in the drive carrier. Pull out the two
locking clasps on the left outside of the carrier and lift out the dummy drive.
2. Install the drive directly into the tray with four screws underneath.
3. Insert the drive carrier into its bay, keeping the release button on the right. When the
carrier reaches the rear of the bay, the release handle will retract.
4. Push the handle in until it clicks into its locked position
Insert this side second
4
2
Figure 3-9. Installing a 3.5" Drive into a Carrier
