SuperServer 6019P-WT8 User's Manual
33
Figure 3-7. Installing Expansion Cards
PCI Expansion Card Installation
The chassis supports one low-profile PCI-E expansion card and two full-height, half-length
PCI-E expansion cards.
Installing an Expansion Card
1. Locate the riser card bracket in your chassis accessory bag and the riser card, which is
purchased separately.
2. Power down the system as described in Section 3.1 and remove the rear cover as
described in Section 3.2.
3. Attach the riser card to the riser card bracket using screws.
4. Insert the riser card into the serverboard expansion slot while aligning the riser card
bracket with the rear of the chassis. Secure the bracket with screws.
5. Remove the PCI shield on the rear of the chassis to expose the opening through which
the PCI I/O ports will extend.
6. Insert the expansion card into the slot on the riser card while aligning the expansion
card backplate with the open slot in the rear of the chassis.
7. Secure the card backplate to the chassis with the locking screw.
8. Replace the chassis cover and power up the system.
Low-profile Card
