Supermicro SUPERSERVER 6013L-8, Руководство пользователя

Страница: 24 / 108

2-8
S
UPER
S
ERVER 6013L-8 Manual
2-5 Checking the Motherboard Setup
After you install the 6013L-8 in the rack, you will need to open the unit to
make sure the motherboard is properly installed and all the connections
have been made.
1. Accessing the inside of the 6013L-8 (see Figure 2-5):
First, release the retention screws that secure the unit to the rack. Grasp
the two handles on either side and pull the unit straight out until it locks (you
will hear a "click"). Next, depress the two buttons on the top of the chassis
to release the top cover. There is a large rectangular recess in the middle
front of the top cover to help you push the cover away from you until it
stops. You can then lift the top cover from the chassis to gain full access
to the inside of the server.
2. Check the CPUs (processors):
You should have one or two processors already installed into the system
board. Each processor needs its own heatsink. See Chapter 5 for instruc-
tions on processor and heatsink installation.
3. Verify the proper CPU clock ratio setting:
If the CPU speed is not automatically detected you will need to set the
correct speed with the DIP switch located on the motherboard. See Chap-
ter 5 for details on the DIP switch to set the correct CPU speed.
4. Check the system memory:
Your 6013L-8 server system may have come with system memory already
installed. Make sure all DIMMs are fully seated in their slots. For details on
adding system memory, refer to Chapter 5.
5. Installing add-on cards:
If desired, you can install add-on cards to the system. See Chapter 5 for
details on installing PCI add-on cards.