Supermicro SUPERSERVER 1028UX-LL1-B8, Руководство пользователя

Страница: 7 / 74

1-2 1-3
Chapter 1: Introduction SUPERSERVER 1028UX-LL1-B8/LL2-B8/LL3-B8 User's Manual
1-2 Serverboard Features
At the heart of the 1028UX-LL1-B8/1028UX-LL2-B8/1028UX-LL3-B8 lies the
X10DRU-XLL, a dual processor serverboard based on the Intel® PCH C612 Express
chipset. Below are the main features of the serverboard. (See Figure 1-1 for a block
diagram of the chipset.)
Processors
The server supports dual Intel processors in R3 LGA 2011 sockets. The 1028UX-
LL1-B8 includes two Xeon E5-2643 v4 processors, the 1028UX-LL2-B8 includes
two Xeon E5-2687W v4 processors and the 1028UX-LL3-B8 includes two Xeon
E5-2689 v4 processors.
Memory
The 1028UX-LL1-B8/1028UX-LL2-B8/1028UX-LL3-B8 features 16 DIMM slots. The
system comes with eight 8 GB preinstalled memory modules for a total of 64 GB
DDR4-2400 MHz low-profile registered ECC memory. Please refer to Chapter 5
for installing memory.
SAS
An onboard LSI 3108 controller on the X10DRU-XLL provides support for SAS 3.0
drives. These drives are RAID 0, 1, 5, 6 and 10 supported.
SATA
Ten SATA 3.0 ports supported by the Intel PCH are included on the serverboard.
RAID 0, 1, 5 and 10 is supported. Refer to the following FTP site for setup guidelines:
ftp://ftp.supermicro.com/driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pd f.
Input/Output
The rear I/O includes a VGA port, a COM port, two USB 3.0 ports, quad Gb LAN
ports and one dedicated IPMI LAN port.
1-3 Server Chassis Features
The 1028UX-LL1-B8/1028UX-LL2-B8/1028UX-LL3-B8 is built upon the
SC119UTS-R751P-T chassis. The following is a general outline of the main features
of the chassis.
System Power
The chassis features a redundant 750W power supply consisting of two redundant,
hot-plug power modules, so one may be replaced without powering down the
system.
Hard Drives
The default chassis supports ten hot-swap 2.5" drives bays, which consist of eight
SAS 3.0 drives and two SATA 3.0 drives.
PCI Expansion Slots
Riser cards and brackets are required to install expansion cards. The system has
two pre-installed riser cards to support three PCI expansion cards as follows. The
RSC-R1UW-2E16 riser for two PCI-E 3.0 x16 add-on cards and the RSC-R1UW-
E8R riser for one PCI-E 3.0 x8 add-on card.
Front Control Panel
The chassis front control panel provides system monitoring lights and power control
buttons. See Chapter 3 for details.
Cooling System
The system has an innovative cooling design that features eight 4-cm counter-
rotating fans located in the middle section of the chassis. Fan speed may be
controlled by IPMI to respond to fluctuations in system temperature.