Supermicro SUPERSERVER 1028UX-LL1-B8, Руководство пользователя

Страница: 43 / 74

Chapter 6: Advanced Chassis Setup
6-3 6-2
SUPERSERVER 1028UX-LL1-B8/LL2-B8/LL3-B8 User's Manual
6-2 Removing Power from the System
Before performing most setup or maintenance tasks, use the following procedure
to ensure that power has been removed from the system.
1. Use the operating system to power down the system <or node>, following the
on-screen prompts.
2. After the system has completely shut-down, carefully grasp the head of the
power cord and gently pull it out of the back of the power supply. If your system
has dual power supplies, remove the cords from both power supplies.
3. Disconnect the cord from the power strip or wall outlet.
6-3 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airflow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Installation."
Before operating the system for the first time, remove the protective film over the
cover of the chassis, in order to allow for proper ventilation and cooling.
Removing the Chassis Cover and Protective Film
1. Peel off the protective film covering the top cover and the top of the chassis
2. Press the two release buttons and slide the cover toward the rear.
3. Lift the top cover up.
Check that all ventilation openings on the top cover and the top of the chassis are
clear and unobstructed..
6-4 Chassis Cover
6-2. Removing the Chassis Cover
Release Buttons
Figure 6-1. Chassis Front and Rear Views
Power Supplies Rear I/O Ports
(see Figure 5-2)
PCI Slots
Control Panel
Hot-Swap Drive Bays (10) USB
Ports