Supermicro SUPERSERVER 1028UX-LL1-B8, Руководство пользователя

Страница: 14 / 74

Chapter 2: Server Installation
2-9 2-8
SUPERSERVER 1028UX-LL1-B8/LL2-B8/LL3-B8 User's Manual
Installing and Removing the Chassis From a Rack
Installation into a Rack
1. Slide the inner rail extensions into the front of the outer rails.
2. Push the chassis backward into the rack until it clicks into the locked postion.
Removing the Chassis From a Rack
1. Press the outer rail latch to release the chassis.
2. Carefully slide the chassis forward, off the outer rails and out of the chassis.
Figure 2-5. Server Installation and Removal
L_min= 638.3(25.1") (OUTER RAIL)
L_min=( 786.4)(31")
L_max= 840.0(33.0") (OUTER RAIL)
( 1538.8)(60.6") (INNER RAIL)
Screw_M5.0
L_max= 840.0(33.0") (OUTER RAIL)
INNER RAIL_FRONT
INNER RAIL_BACK
Outer Rail
Latch
Installing the Server into a Telco Rack
Optional brackets are needed to install the server to a telco (open type) rack.
To install the server into a Telco type rack, use the two L-shaped brackets on either
side of the chassis (four total). First, determine how far follow the server will extend
out the front of the rack. Larger chassis should be positioned to balance the weight
between front and back. If a bezel is included on your server, remove it. Then
attach the two front brackets to each side of the chassis, then the two rear brackets
positioned with just enough space to accommodate the width of the telco rack.
Finish by sliding the chassis into the rack and tightening the brackets to the rack.
Figure 2-6. Installing the Server into a Telco Rack
Note: Figures are for illustrative purposes only. Servers should always be installed
into racks starting at the bottom.
Note: The figure above is for illustrative purposes only. Always install servers at
the bottom of the rack first.
Warning : Do not pick up the server with the front handles. They are designed
to pull the system from a rack only.