49
48
Chapter 4: Motherboard Connections
SuperServer 1019S-M2 User's Manual
Data Cables
The data cables in the system have been carefully routed to maintain airflow efficiency. If
you disconnect any of these cables, take care to re-route them as they were originally when
reconnecting them.
Important!
Make sure the the cables do not come into contact with the fans.
Power Cables
The following power connections on the X11SSZ-QF must be connected to the power supply.
The wiring is included with the power supply. See Section 4.1 for details.
•
24-pin Primary ATX Power (JPW1)
•
8-pin Processor Power (JPW2)
•
CMOS Battery Power (J18)
NMI Button
The non-maskable interrupt button header is located on pins 19 and 20 of JF1.
NMI Button
Pin Definitions (JF1)
Pin#
Definition
19
Control
20
Ground
4.3 Ports
Serial Ports
Two COM ports (COM1 & COM2) are provided on the motherboard. Both are located near
the PCI-E slot 4.
Rear I/O Ports
See the figure below for the locations and descriptions of the various I/O ports on the rear
of the motherboard.
SATA Ports
The X11SSZ-QF includes a total of four SATA ports, supported by the Intel Q170 PCH chip.
These SATA ports support RAID 0, 1, 5, and 10.
Figure 4-2. Rear I/O Ports
Rear I/O Ports
#
Description
#
Description
#
Description
1.
IPMI LAN Port
5
USB2 (3.0)
9
DVI Port
2.
USB1 (2.0)
6
LAN2 Port
10 Display Port2
3
USB0 (2.0)
7
LAN1 Port
11 Display Port1
4
USB3 (3.0)
8
VGA Port
1
9
8
7
6
5
4
3
2
10
11
LAN Ports
There are two LAN ports (LAN1/LAN2) on the I/O back panel. There is also a dedicated IPMI
LAN port on the I/O back panel. These ports accept RJ45 type cables. Please refer to the
LED Indicator section for LAN LED information.
