SuperServer 1019S-M2 User's Manual
Chapter 2: Server Installation
24
23
Note:
Figure is for illustrative purposes only. Always install servers to the bottom of a rack first.
Note:
Figure is for illustrative purposes only. Always install servers to the bottom of a rack first.
Installing the Server into the Rack
1. Align the chassis rails with the front of the rack rails.
2. Slide the chassis rails into the rack rails, keeping the pressure even on both sides. The
spring latch engages when the chassis is part way in. Push the server completely into
the rack.
3. (
Optional
) Insert and tighten the thumbscrews that hold the front of the server to the
rack.
Figure 2-3. Installing the Server into a Rack
Figure 2-4. Installing the Server into a Telco Rack
Installing the Server into a Telco Rack
Optional brackets (p/n MCP-290-00016-0N) are needed to install the server to a Telco (two
post type) rack. Use the two L-shaped brackets on either side of the chassis (four total).
1. First, determine how far follow the server will extend out the front of the rack. Larger
chassis should be positioned to balance the weight between front and back. If a bezel is
included on your server, remove it.
2. Attach the two front brackets to each side of the chassis, then the two rear brackets
positioned with just enough space to accommodate the width of the telco rack.
3. Finish by sliding the chassis into the rack and tightening the brackets to the rack.