Supermicro SUPERSERVER 1018R-WC0R, Руководство пользователя

Страница: 33 / 76

Chapter 5: Advanced Serverboard Setup
5-7 5-6
S
UPER
S
ERVER 1018R-WC0R User's Manual
7. With the CPU in the socket, in-
spect the four corners of the CPU
to make sure that they are flush
with the socket.
8. Close the load plate. Use your
thumb to gently push the lever
labeled 'Close 1st' then the lever
labeled 'Open 1st' down until they
lock.
9. Repeat steps to install to the
remaining CPU socket.
OPEN 1st
Lever Lock
Push down
and lock the
lever labeled
'Open 1st'.
OPEN 1st
Push down and lock the
level labeled 'Close 1st'.
Gently close
the load plate.
Installing and Removing a Passive CPU Heatsink
1. Do not apply any thermal grease to the heatsink or the CPU die; the required
amount has already been applied.
2. Place the heatsink on top of the CPU so that the four mounting holes are
aligned with those on the serverboard and the heatsink bracket underneath.
3. Screw in two diagonal screws (i.e., the #1 and the #2 screws) until just snug
(to avoid possible damage to the CPU, do not over-tighten the screws.)
4. Add the two remaining screws then fully tighten all four screws.
Figure 5-3. Installing the Heatsink
Note: be aware that the heatsink for CPU1 must be installed in the correct orien-
tation: the air tunnel must be on the right side when viewed from the front of the
system. (Above figure shows heatsink viewed from the rear.)
Loosen screws
in sequence as
shown.
Screw #2
Screw #1
Screw #3
Screw #4
Removing the Heatsink
Caution: Removing the CPU or the heatsink is not recommended. However, if
necessary, please follow the instructions below.
1. Unscrew the heatsink screws from the serverboard in the sequence shown.
2. Gently wriggle the heatsink to loosen it from the CPU (do not use excessive
force). Once the CPU is loose, remove the it from the CPU socket.
3. Clean the surface of the CPU and the heatsink to remove the used thermal
grease. Reapply the proper amount of thermal grease then re-install the CPU
and the heatsink.