Supermicro K1048-RT, Руководство пользователя

Страница: 21 / 66

Chapter 2: Server Installation
2-7
2-6 Power-up/Power-down Sequence
The K1048-RT system's power up/power-down sequences and indications are
shown below.
Powering-up the System
Timing Indications
Plug the system into power source PSU LED will light
Wait 30 Seconds None
30 Seconds after power cord is plugged in BMC ready/ onboard LED fl ashes (seen through
air vent(chassis/ rear) Indicating the board
management has booted successfully
Push-on Power button Button LED turns green
Drives spin up, switch initializes * Depending on environmental temperature Fans may
not spin-up like a typical server power-up
~15-30 seconds after power button is pressed,
Ethernet drives are available for DHCP address
assignment on the redundant networks Internal link LEDs are lit solid on the mainboard
PHY indicators
*Initial boot/spin-up may be silent.
Powering Off the System
Timing Indications
Hold power button for 6 seconds, then release None
System shutdown will occur within seven seconds Power button LED will go dark
BMC remains powered on accessible until system
is unplugged