Supermicro 8042-6, Руководство пользователя

Страница: 68 / 114

6-6
S
UPER
S
ERVER 8042-8/8042-6 Manual
6-4 Drive Bay Installation/Removal
Accessing the Drive Bays
SCSI Drives: You do not need to access the inside of the chassis to
replace or swap SCSI drives. Proceed to the next step for instructions.
Note: You must use standard 1" high, 80-pin SCA SCSI drives in
the SuperServer 8042-8/8042-6.
CD-ROM/Floppy Disk Drive: For installing/removing the CD-ROM or floppy
disk drive, you will need to gain access to the inside of the 8042-8/8042-
6 by removing the top cover of the chassis. Proceed to the "CD-ROM
and Floppy Drive Installation" section later in this chapter for instructions.
Note: Only a "slim" CD-ROM drive will fit in the 8042-8/8042-6.
Replacing System Exhaust Fans
1. Removing a hot-plug fan housing:
With the chassis cover removed, first unplug the fan cable corresponding
to the failed fan. Next, push down on the locking tabs at the top and
bottom of the fan housing, which protrude through the back end of the
chassis. This will detach the housing from the chassis. Reach inside the
chassis and pull the housing out of its hole in the chassis. Unscrew the
four screws that hold the fan in the housing to remove the bad fan.
2. Installing a new system exhaust fan:
Replace the failed fan with an identical 9-cm, 12 volt fan (available from
Supermicro). After the new fan has been installed, reassemble the fan
housing. To put it back in the chassis, firdst insert the bottom fan
housing tab into its hole, then swing the top of the fan toward the
chassis, pushing down on the top fan housing tab to to insert it into the
corresponding hole in the chassis. You should hear it click into place
when fully inserted. Finish by plugging the fan cable back into the same
power connector you removed it from. Check that the fan is working
properly and that the LEDs on the control panel circuit board (Figure 6-2)
and the control panel have turned off. Finish by replacing the top panel
of the chassis.