12
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 10
Surround Panels Installation
The SDVI insert surround panels are made of heavy gage steel for durabil-
ity and, if desired, for the ease of making an inside fit in the fireplace.
1. Remove the speed nuts (A in
Figure 12
) from the parts bag and
install (with the flat surface forward) on the six holes in the surround
brackets - three on each side of the insert (B in
Figure 12
). A flat
bladed screwdriver may help in installing the nuts.
2. Install all surround panels and trim with the insert positioned in the
fireplace but a few inches in front of its final location.
3. Install the side surround panels by lining up the holes in the tabs
on the side surround panels in front of the holes on the surround
brackets. Next insert two slotted 1/4" truss screws for each side
surround panel and secure loosely.
Face Installation
The faces come with hooked brackets. To install the face, hang the hooked
brackets on the surround brackets per
instructions provided in decorative
face kit (C in
Figure 12
).
Figure 12
A
B
C
Spring Handle Latches
Door Mounting Plates
4. Fasten top surround panel with the remaining two truss screws.
Tighten all six truss screws after adjusting the surround panels to
eliminate space between side and top surround panels.
5. Assemble the surround trim by inserting the elbowed retainer in the
rectangular slot in the ends of the longest piece of trim and secure by
tightening the screw in the retainer. Slide the mitred ends of the two
side trim pieces onto the elbowed retainer and secure by tightening
the retainer screw.
6. The fastened trim pieces should now be horseshoe shaped. Slide
the trim down over the surround panels so the edge of the surround
panel fits just behind the rounded edge of the trim.
7. Install three spring clips (found in parts bag in firebox) in each piece
of trim by inserting them between the rear of the surround panel
and the channel of the trim. The spring clips will push the trim tight
to the surround panel.
Install front logs
on retainer slots
Place Top Log On Pin
Top Log
Ports
Front Logs
Figure 11
