SuperiorFireplaces.us.com
900855-00_B
20
Door rail
Top Face
Screw
Spring
Clip
GLASS DOOR INSTALLATION
Figure 41 - Installing Bi-Fold Doors
Figure 40 - Installing Door Rail
Spring Clip
Insert Pin into
Spring Clip
Pivot
Hole
Insert
Bottom Pivot
Pin into Hole
Fold Door and
Slide Top Pins
Into Track
Figure 42 - Adjusting Bi-Fold Doors
INSTALLING OPTIONAL GLASS DOOR MODELS 38LBF and 43LBF
Use only the doors that are listed for use with these fireplaces. Use
of other non-listed glass door on these fireplaces may constitute a
potential fire hazard and is not recommended.
Note:
Top door rail, and spring clips are provided with the glass
door kit.
1. Using a Phillips screwdriver, remove the three (3) factory
installed screws underneath top front face.
2. Position the door rail and secure it with one (1) of the screws
removed, start from the middle as shown in Figure 40.
3. Using remaining two (2) screws, secure both the spring clips
and the rail for the left and right sides as shown in Figure 40.
WARNING
This kit is to be installed by a qualified service
technician or other qualified agency in accordance
with the manufacturer's instructions and all codes
and requirements of the Authority Having Jurisdiction
in the USA or Canada. If these instructions are not
followed exactly, a fire or explosion may result,
causing property damage, personal injury, or loss
of life. The qualified agency performing this work
assumes responsibility for this installation.
4. With bi-fold doors completely folded, insert bottom pivot pin
into pivot hole located near bottom corner of front face opening
and swing door to vertical position making sure top pins slide
into door track. Door is installed when top door pin snaps into
spring clip (see Figure 41).
5. Repeat step 4 for remaining door.
If you find doors do not close properly or do not appear level or
straight, proceed with section on door adjustment.
DOOR ADJUSTMENT
Remove doors and slightly loosen upper spring clips. Replace
doors and fully close them. Use 1/8" shims (any material) to
level doors. Once proper setting is achieved, carefully open
doors enough so that you can access spring clips with a Phillips
screwdriver. Tighten screws. See Figure 42.
