10
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
ELECTRONIC IGNITION WIRING DIAGRAM
BROWN
BROWN
BLACK
WEATHER
SEAL
COVER
REMOTE
WALL
SWITCH
REMOTE WALL SWITCH
D-CELL BATTERIES
BATTERY
WALL SWITCH BOX
WALL SWITCH BOX
BLACK
BLACK
IGNITER MODULE - 3V
RED
PILO
T
IN
OUT
VENT
LO
HI
TH
TP
TH
TP
IN
ORANGE
BLACK
GREEN
BLACK JUMPER
HIGH LIMIT
SWITCH
UMBILICAL CORD (9 Feet)
NOTES:
1. If any of the original wire as supplied must be replaced, use Type AWM 105°C - 18 gage wire ONLY.
2. Electrical Rating: 3V DC.
CAUTION: label all wires prior to disconnection when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify proper operation after servicing.
Schematic Representation Only
ELECTRONIC GAS CONTROL VALVE - DEXEN
PILOT TUBE
(THTP)
(TP)
(TH)
PILOT BURNER
IGNITER-SENSOR
ASSEMBLY
PILOT SENSOR CABLE
SPARK WIRE CABLE
FLAME
SENSOR
IGNITER
ROD
Figure
11
FIELD WIRING
CAUTION: LABEL ALL WIRES PRIOR TO DIS-
CONNECTION WHEN SERVICING CONTROLS.
WIRING ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION. VERIFY PROPER
OPERATION AFTER SERVICING.
Refer to
Figure 11
for the wiring schematic
for these fireplaces.
This fireplace is completely wired internally.
On the right hand side of the fireplace, at the
rear, are four (4) wires required to connect the
Battery and switch for operation.
Two brown wires are for the connection of the
switch. These are labeled SW and SW. A black
and red pair are for connection to the battery
pack. These are labeled (+) and (–).
Figure 12
Switch
Cover
Weather Seal
Orient Batteries Vertically
To Fit Within Box
These wires are for low voltage current. An
electrical box has been provided to contain both
the switch and battery pack. Mount the box in
an appropriate location within the length of the
wiring provided. Feed all four wires through one
of the lower inlets to the box. Connect the switch
wires to the switch and the corresponding (+),
(–) to the battery holder.
Install two D-cell batteries (not provided) and
test the switch before closing the switch box
(refer to
Figure 12
)
. The igniter should spark
to the pilot when the switch is on.
Wiring diagrams are provided here for refer-
ence purposes only. This information is also
provided on schematics attached directly to
the appliance on a pullout panel located within
the control compartment.
