45
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Care and Operation
900358-00, 01/2018
Innovative Hearth Products
DRT63STTYN Power-Vent
Separate glowing ember material
into
THIN
, square, dime-sized pieces.
Figure 64 - Preparation of Glowing Ember Material
Bag of Glowing Embers
C
A
B
Figure 65 - Placement of Glowing Ember Pieces
Control Side
Figure 66 - Placement of Glowing Embers
Place
embers
in circled
areas.
PLACEMENT OF VOLCANIC STONE, GLOWING EMBERS,
AND LOGS
1.
Remove glass door and barrier from one side of fireplace only (see
Page 44
).
2.
Locate materials (log set, bag of glowing embers, and bags of volca-
nic stone).
NOTE: LOGS ARE FRAGILE!
Handle with care to prevent
breakage.
3.
Install volcanic stone. Place some of the volcanic stone on the firebox
floor around the grate (the entire bag of volcanic stone will NOT be
used).
NOTE:
Do NOT place volcanic stone on burner.
4.
Prepare and install glowing embers.
NOTE:
This appliance is provided with enough glowing
ember material for several applications. Do NOT use the
entire contents of a new bag at one time.
a) Separate some of the glowing ember material into pieces
about
the size and thickness of a dime
(see
Figure 64
). Keep the pieces
fluffed up, not matted.
IMPORTANT! Ember pieces must be
as SMALL and THIN as a dime.
b) Distribute the dime-sized pieces over the surface of the burner, in
the areas shown in
Figures 65 and 66
.
NOTE:
To prevent flame impingement and soot, do not use
more ember material than necessary.
c) For best glowing effect, replace ember material annually.
NOTE:
Use only catalog number
H8312
Platinum Glowing
Embers with this fireplace.
Control Side
(top view of burner shown)
•
Place glowing ember material in circled areas ONLY.
•
Do NOT place glowing ember material over main flame gas ports.
•
To prevent flame impingement and soot, do not use more ember
material than necessary.
WARNING
•
DO NOT attempt to install the logs until the appli-
ance installation has been completed, the gas line
connected and tested for leaks, and the initial burner
operation has been checked out.
•
Logs get very hot and will remain hot up to one hour
after gas supply is turned off. Handle only when
logs are cool. Turn off all electricity to the appliance
before you install
volcanic stone, embers and logs.
•
The size and position of the log set was engineered
to give the appliance a safe, reliable and attractive
flame pattern. Any attempt to use a different log
set in the fireplace will void the warranty and will
result in incomplete combustion, sooting, and poor
flame quality.
•
This appliance is not designed to burn wood. Any
attempt to do so could cause irreparable damage to
the appliance and prove hazardous to your safety.
•
If logs are not installed according to the log installa-
tion instructions, flame impingement and improper
combustion could occur and result in soot and/or
excessive production of carbon monoxide (CO), a
colorless, odorless, toxic gas.
NOTE: It is important to ensure proper log placement per the
manual when installing these units. Verify pilot flame is not
obstructed. See Verifying Appliance Operation on Page 25.
