Operation
900966-00B, 04/2019
Innovative Hearth Products
DRT3000-C Series Direct-Vent Gas Fireplaces
59
Installing the DRT3000-C 40 Series Log Set
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs. Proper log placement is
critical to prevent sooting. Place the logs in the gaps between flame peaks, so they do not impinge the flames. Follow the log placement
instructions precisely.
NOTE: Do not cover the burner ports.
Table 31 - Log Set
I.D.
No.
Description
1
Rear Log
2
Bottom Left Log
3
Middle Ember Log
4
Right Twig Log
5
Left Twig Log
6
Middle Twig Log
1. If necessary, remove the glass door (Pages 63-64).
2. Tear the glowing embers into dime size pieces. Place glowing embers as shown in Figure 46.
3. Locate and bend up the log placement tabs (Figure 47).
4. Place the Rear Log(1) on to the back left tab (b) and the right side tab (e) (Figures 47 and 48).
Figure 47 - Locate and bend up the log placement tabs
Figure 48 - Place Rear log (1)
Catalog number for the entire set: See Page 77.
1
3
5
6
4
2
1
4
2
3
5
6
a
b
c
d
e
Tabs for
Log #1
Tabs for
Log #3
Tab for
Log #2
Bottom View
1
Figure 46 - Place Glowing Embers (rockwool)
Fits over Tab “e”
(Figure 47)
Fits over Tab “b”
(Figure 47)
Do NOT place embers on or close
to large ports or the pilot area.
NOTE: Enough glowing ember material
is provided for several applications. For
best glowing effect, replace the ember
material annually.
Pin for Log (6)