Operation
900285-00 12/2016
Innovative Hearth Products
DRT3000 and DRC3000 Series Direct-Vent Gas Fireplaces
56
Installing the 33” and 35” logs
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs. Proper log
placement is critical to prevent sooting. Place the logs in the gaps between flame peaks, so they do not impinge the
flames. Follow the log placement instructions precisely.
NOTE: Do not cover the burner ports.
Table 38 - 33” and 35” Log Set
Log Number
Description
1
Rear Log
2
Left Front Log
3
Right Front Log
4
Left Cross Log
5
Right Cross Log
NOTE: Fireplace shown with optional brick panels.
1. If necessary, remove the glass door (Page 58). Locate left and right placement brackets (Figure 50).
2. Locate the log placement brackets (Figure 50). Place embers and other media (see Page 55).
Figure 50 - Locating the log placement brackets
Figure 51 - Placing logs 1 and 2
3. Align the notches in the bottom of the rear log (1) with the left rear brackets (Figures 51)
4. Position the left rear log (1) on the left rear bracket and the left front log (2) on the left front log bracket and the
left burner locating tab (Figures 51).
Figure 52 - Placing log 3
Figure 53 - Placing log 4
5. Position the right front log (3) on the right front log bracket and right burner locating tab (Figure 52).
6. Position the left cross log (4) on the left rear log (1) and right cross log (5) on the right rear log bracket
(Figure 53).
NOTE: It is important to ensure proper log placement per the
manual when installing these units. Verify pilot flame is not
obstructed. See Verifying Appliance Operation on Page 41.
Catalog number for the entire set:
F1883
-
33” Models
F1829
-
35” Models
4
5
3
2
1
Left Log Bracket (front & rear) Right Log Bracket (front & rear)
Left and Right Burner Locating Tabs
1
2
3
4
5