SuperiorFireplaces.us.com
900807-00_A
13
Figure 23 - Installing Logs 1 and 2
Figure 24 - Installing Logs 3 and 4
Figure 25 - Installing Logs 5 and 6
INSTALLATION
Continued
LOG PLACEMENT FOR MODEL BRT 4036TEN-B 4336TEN-B,
4536TEN-B, 4036TEP-B, 4336TEP-B, 4536TEP-B
1. Place small front right log (log 1) on right front of grate as shown
in
Figure 23
.
2. Place large back log (log 2) onto grate making sure notches rest
over grate as shown in
Figure 23
.
3. Place log 3 into notch on log 2, resting front end on top of log 1
(see Figure 24).
4. Place upper end of log 4 into notch on log 2 as shown in
Figure
24
. Rest lower end of log 4 onto middle grate finger as shown in
Figure 25
.
5. Place upper end of log 5 into notch on left of log 2
(see Figure
25).
Rest lower end of log 5 on grate as shown in
Figure 26
.
6. Insert lower end of log 6 between first two grate fingers as
shown in
Figure 26
and position upper end of log 6 into notched
area on front of log 2 as shown in
Figure 26
.
As an option to enhance the look of the hearth, you may place volcanic
stone provided around front and sides of burner.
NOTE: It is important to ensure proper log placement per the manual
when installing these units. Verify pilot flame is not obstructed. See
Inspecting Pilot and Burner Flame Patterns on Page 18.
NOTICE: Do not put volcanic stone inside the burner
pan or around the air mixer fitting. Placing volcanic
stone inside the burner pan or blocking the openings
of the propane/LP air mixer could cause performance
problems.
1
J4246
LOG, FIREPIT SPLIT 9"
2
J7241
LOG, REAR 22"
3
J4242
LOG, TOP ROUND 11-3/4"
4
J4243
LOG, TOP SPLIT 16"
5
J4244
LOG, Y TOP SPLIT 13-1/2"
6
J4245
LOG, TOP 11"
Log 1
Log 2
Notch
Log 3
Log 4
Notches
1
2
Log 5
Log 6
Notch
Notch
3
4
2
1
Figure 26 - Logs Installed for 36" Models
1
2
3
4
5
6
