Superabrasive
Owner’s Manual –
Lavina 7
Pro
1/2012
6
Mount the tools only after ensuring that there is enough diamond bond material left. Be sure that the plates are always
clean before mounting. Before dismounting or mouting the tools unplug the machine. Always use the tool holder key,
turn the butterfly in the middle to ensure the tool (Fig.3.1).
Diamond tools with Velcro are attached on the foam plate of 7 inch (Fig. 3.3). The foam plate (is mounted the same way
as the other tools (Fig. 3.2).
LEVELING AFTER MOUNTING THE TOOL
To ensure the tool works flat on the floor, the
machine has to be leveled. On top of the base
plate is mounted a round water level (Fig. 3.5).
Attention using the water level should be done
only on a flat surface.
To level the machine, turn the knob between
the wheels (Fig. 3.4).
ADJUSTING HANDLE AND SWIVELLING CARRIAGE
For adjusting the handle in height, turn loose the swivel bolt, after finding the right position lock it back (Fig. 3.6).
Find the right angle of working the machine (Fig. 3.7), swivel left or right the carriage by unblocking turning wheel (Fig.
3.8).
TOOL PROTECTING GUARD
Turn the tool protecting guard in the preferred position. Adjust the height according
the tool while mounting on the “Velcro” strip. (Fig. 3.9)
THE CONTROL BOARD
1. Lamp
jack
plug out/in the lamp when needed
2. Potentiometer
changes the RPM of the grinding plates,
from 500-1100 rpm
3. ON/OFF
switch
starts/stops
motor
Power led
lights green when the power is on
4. Emergency
button
used in Emergency situations for stopping the motor
STARTING THE MACHINE
First, follow the directions in chapter Safety Devices and Safety Instructions.
Next, pull the emergency stop (Fig. 3.10 4) to ensure that the machine is in
working condition. Check the potentiometer (Fig. 3.10 2) and ensure that it is
set at the working speed. Switch on the vacuum unit. Finally, hold the machine firmly and switch the start button (Fig.
3.10 3).
Figure 3.4
Figure 3.5
Figure 3.7
Figure 3.6
Figure 3.8
Figure 3.10
Figure 3.9
