Superabrasive
Owner’s Manual –
Lavina 7
Pro
1/2012
7
Figure 4.3
OPERATING THE MACHINE
Guide the machine in straight lines across the floor, and with each new line overlap a little bit of the previously
completed surface. Work at a constant speed allowing the tools time to work at a speed appropriate for the tools’ grit
size. Avoid vibrations. Do not stop the Lavina 7 Pro machine in one spot while the tools are still working because they
will leave marks on the floor surface. Check the floor surface periodically to ensure that dust is not accumulating on the
surface, also check regularly if your vacuum works properly.
STOPPING THE MACHINE
The stopping of the machine must be done gradually until the motor stops. Do not stop moving the machine before
arresting the motor as the tools could damage the surface. Switch off with the off button (Fig. 3.10 3). Use the
Emergency button (Fig. 3.10 4) only in emergency or use it to switch the power totally off.
Remember not to hold the machine in one spot before turning off the motor.
4. TOOLS AND ACCESSORIES
WEIGHTS
Superabrasive offers additional weights for increasing the productivity of the
machine (Fig.4). Each additional weight weighs about 5.5 lbs or 2,5 kg. Each
individual application, type and condition of surface, power capacity of the outlet,
etc. will determine the number of weights you can use without tripping a breaker,
Although wit a maximum of four. The weight stacks on to central shaft above the
toolts around the outer bowl (Fig.4.1).
The additional weight depends on the tools; it is not always possible to add
weights. Some tools work too aggressively and the machine can stop.
TOOL HOLDER KEY
The tool holder key (Fig. 4.2) is used for adjusting, mounting and dismounting of the
tools. Always use the key for mounting. Item number is A03.00.00.00
FOAM PLATE
Diamond tools with Velcro are mounted on the
foam plate 7“(Fig.4.3). The foam plate is
mounted on the flexible backer plate.
Item number is LV-7-FP
FLOATING BACKER PLATE
A floating backer plate (Fig. 4.3) is mounted on the grinding head. Its advantage is that it has elastic shock absorbers,
which enable the tool plate to float and follow the surface profile. A tool can be attached with use of the tool holder key.
To order any parts, customer has to provide the machine model and serial number. Without
this information, customer is responsible for ordering the correct part, and no shipping
charges will be refunded if the part ordered is wrong.
Item
Number Description Qty.
1 A01/00.00.02 Sealer
Front 1
2
М
6
х
20DIN7991 Screw 4
3 A01/00.00.01 Shock
Absorber
4
Figure 4.2
Figure 4.3
Figure 4.1