Super Vac 718G4T, Руководство пользователя

Страница: 5 / 15

POSITIVE PRESSURE VENTILATOR
4
718G4T_PPVentilatorUserGuide-Tecumseh.doc REV. 03/18/03
3. Product Safety Precautions
Ø
Do not use the ventilator for purposes other than its’ intended use.
Ø
Wear eye and ear protection when operating the ventilator.
Ø
Never operate ventilator while fatigued.
Ø
Do not disassemble or modify the ventilator in any way. Doing so may lead to mechanical failure or personal injury.
Ø
Do not wear loose clothing that could become entangled in the operating ventilator.
Ø
Never permit anyone to operate ventilator without proper instruction.
Ø
Do not operate ventilator without proper inlet or outlet guards in place. If guards are missing or damaged, contact
factory for replacements.
Ø
Do not place fingers or other foreign objects through inlet or outlet guards. Should a foreign object enter the ventilator,
immediately stop engine. Be certain all mechanical motion has stopped. Disconnect spark plug wire from spark plug and
keep it away from spark plug before removing foreign object.
Ø
Do not use with any fuel supply source other than the provided fuel tank.
Ø
Engine exhaust gas contains poisonous carbon monoxide. Avoid inhalation of exhaust gas. Never run the engine in a
closed or confined area.
Ø
Do not place or operate ventilator on unsteady tables, slanted surfaces or other unstable surfaces.
Ø
Never use this ventilator in any explosive environment.
Ø
Do not use chock blocks to increase the angle of the ventilator, severe injury could occur.
4. Before Operating Ventilator
§
Engine is shipped without oil. With engine in a level position, remove oil fill plug and dipstick. Fill with 21 ounces of
the recommended oil. See page 1 of the
TECUMSEH Operator’s Manual for oil viscosity recommendations and
capacity.
§
Always operate this ventilator with unleaded gasoline having a pump octane rating of 85 or higher.
§
A complete inspection of the ventilator should be made prior to operation.
§
Check all threaded fasteners for proper tightness.
§
Inspect inlet and outlet guards for damage or missing pieces. Replace damaged or missing guards before operating
ventilator.