Updated: 15 November, 2011 Page 7
REF: REI-85-0045
BUZZER :
Warning sounds when machine function encounter error.
Note: To turn off sound, press “F1” key on HMI.
TEMPERATURE :
This is how to manage the temperature setting in degrees centigrade (
o
C).
SETTING FOR TEMPERATURE:
The Orange number means the actual temperature of the heater and the Green means the desired
setting.
Press the “
︿
”
、
”
﹀
”
、
”
〈
“ for adjust the Green temperature.
And press the “ENT” to save when finish the adjusting.
Then Press “Run” to Start or Stop heat, and it ‘s start to Heat if shows the 2 Green light, and Stop to
Heat if not.
Polypropylene, PVC or PET films could have the default settings of 135 to 250
o
C. This will vary
based on the type of containers and sealing films used.
5.
ROLL FILM SET-UP
Setting Up the film roll is a simple step of following the direction as per the images below – with printer or
without the printer. The printer will stamp product information on the film such as the expiry date,
manufacturing date / time.
1. Follow the film dressing process below. Keep the film in right direction as shown below.
2. When the power is on, the printer heater will start heating up automatically.
3. It takes 5~7 minutes to reach the set temperature set. (Manually adjusted)
4. The indicative lamp will be “off” automatically when the set temperature reached. Then the machine is
ready for the container to make sealing function.
5. Choose the correct film material:(It is important for good sealing)