Supco VLTS, Руководство по эксплуатации, Страница: 36 / 44

Temperature recorder and printer
34
C
HAPTER
6 S
OLVING
P
ROBLEMS
Table 5 below lists the most common problem and the ways to solve them.
P
ROPOSED SOLUTION
I
SSUE
• Make sure there power is supplied to the device.
• Wait 5 seconds after OK/On is pressed.
The device does not
turn on when OK/On
is pressed
• The device is working on the backup battery only, make sure there
power is supplied to the device.
• Replace the external power adaptor if connected. Should be 12V, 2A
The device display
turns on shortly when
OK/On is pressed and
the Power LED is
blinking
• Change the print mode from Disable to another style. See
“ Printing ”, page 11.
• Make sure you are using thermal printing paper.
• Replace the print side of the thermal paper or replace the paper roll
to thermal paper.
• Move the VLTS device to a place where the temperature is in the
range of -18ºC to 65ºC
No printing or weak
printing
• Change the printer to Disable mode. See “ Printing ” , page 11. Paper waste/ Cancel
printing
• Change the date or time. See “ Setting the Time and Date ” on page
24.
• Make sure the date is in the correct format. See “ Setting
Temperature Scale and Date Format": on page 24.
• Replace the CR2032 clock battery. See “ Installing and Replacing the
Batteries ” on page 9.
• Remove the batteries, the CR2032 3V and 9V and pull out the
power cord for 5 minutes, then reinstall them. See page 9.
Wrong date or time
• See “ Changing the Sampling Rate ” , page 26.
Incorrect sampling
rate
• See “ Setting Sensor Types ” , on page 18. Sensor type not set
• To mute the buzzer one time, press on EXIT.
• To turn off the horn completely, see “ Setting up Additional Alarm
Events ” , set the buzzer to No , page 22.
Buzzer annoys
• Check “ Setting Alarm Limits to Sensor ” and the delay time, page 21.
• Check that the buzzer is set to YES. See “ Setting up Additional
Alarm Events ” , page 22.
No alarm when the
temperature is out of
range
• See “ Renaming the Device for Identification ” , page 25.
• See “ Renaming Channels for Sensor Identification ” , page 20.
Incorrect device/
vehicle name or
sensor name
• To backspace and delete the last (flashing) character, press Can't erase the last
character we'll
entering names
• Enter the factory default password: , , , .
• Update password. See “ Changing the Password ”, page 25.
Forgot your
password?