Sunx SF4B 01 Series, Инструкция по эксплуатации

Страница: 57 / 102

SUNX Limited MJE-SF4B01 No.0005-03V
- 57 -
2-6
Adjustment
2-6-1 Beam-axis Alignment
1. Turn ON the power supply unit of this device.
2. Check that the digital error indicator (red) and the fault indicator (yellow) of the emitter and
receiver are off respectively.
If the digital error indicator (red) or the fault indicator (yellow) lights up or blinks, refer to
‘
Chapter 5 Troubleshooting ’, and report the symptoms to the maintenance in charge.
3. In case of using the intermediate supporting bracket ( MS-SFB-2 ), loosen the two hexa-
gon-socket head bolt [M5 (please arrange separately)].
4. In case of using the standard mounting bracket ( MS-SFB-1 ) (optional) for mounting this
sensor, loosen the two hexagon-socket head bolt for alignment of the standard mounting
bracket so that the emitter and receiver face to each other.
The marks are engraved on the standard mounting bracket A, which enables the angle of
the emitter / receiver to be adjusted by 30 degrees.
5. Tighten the hexagon-socket head bolt for alignment of the standard mounting bracket.
The tightening torque should be 2N
㨯
m or less.
6. Loosen the hexagon-socket head bolt for beam axis alignment of the standard mounting
bracket, and adjust the emitter / receiver so that the beam-axis alignment indicators in the
display of the emitter and receiver light up.
The emitter and the receiver can be fine-adjusted by ±15 degrees.