Synway Information Engineering Co., Ltd
SMG Series Analog Gateway User Manual (Version 1.5.3)
Page 10
for detailed instructions. You may use the default values of other
configuration items and are required not to leave ‘Description’ empty.
Example:
Provided the FXS port which is connected with a station is Port1, check the
checkbox before
Port1
, set
Index
to
1
, fill in
Description
with
test
, and keep the default
values of other configuration items.
2. Go to ‘Route Settings
Æ
IP
Æ
Tel’ on the WEB interface and click the ‘Add New’ button to add
for detailed instructions. Fill in ‘Source IP’ with the
IP address which initiates the call and select the port group created in Step1 as ‘Destination
Port Group’. You may use the default values of other configuration items and required not to
leave ‘Description’ empty.
Example:
Provided the IP address of the IP phone which initiates the call is 192.168.0.111.
Set
Index
to
63
,
Destination Port Group
to
1
, fill in
Description
with
test
, configure
Source
IP
to
192.168.0.111
, and keep the default values of other configuration items.
3. Pick up the IP phone and call the IP address and port of the SMG analog gateway to ring the
station.
Example:
Provided the IP address of the SMG analog gateway is 192.168.0.101 and the port
is 5060, use the IP phone to call the IP address 192.168.0.101 and the station connected with
Port1 will ring.
Step 10: Enable the auto dial feature. (Skip this step if not necessary.)
Go to the Port Settings interface to enable the auto dial feature and set the parameters ‘Auto Dial
Number’ and ‘Wait Time before Auto Dial’. If there is no dialing operation in a time period (i.e. Wait
Time before Auto Dial) after pickup, the port will automatically call the preset number (i.e. Auto
Dial Number). Refer to
for detailed instructions.
Step 11: Enable the DND (do not disturb) feature. (Skip this step if not necessary.)
Go to the Port Settings interface to enable the DND feature. Then, the FXS port will reject all
incoming calls. Refer to
for detailed instructions.
Step 12: Enable the call waiting feature. (Skip this step if not necessary.)
Go to the Port Settings interface to enable the call waiting feature. Then the corresponding FXS
port while in conversation can accept another call from IP and keep it in the waiting state. Once
the current conversation is finished and the station hangs up, the call in the waiting state will ring
the station and wait for answer. During the time in the waiting state, it will always hear the ringback
tone from the FXS port. Refer to
for detailed instructions.
Step 13: Perform call forwarding. (Skip this step if not necessary.)
Situation 1: Hook-flash operation
Figure 2-4 Call Forward via Hook-flash
As shown above, Remote A initiates and establishes a call with Station. Then by a hook-flash
operation, that is, a rapid clap on the hook or pressing the ‘flash’ button on the phone set, Station
can forward the call to Remote B.
Once a flash is generated, Station will go into the dialing state (the FXS port sends it dialing tones)
before it dials the forwarding number.
Station
IP call in
Recover the call with Remote A/
Switch the call to Remote A or
Remote B
Call Forwarding
Go into a talk once Station hangs up
Remote A
Remote B
