SunSynk ECCO SUN-3.6K-SG04LP1-EU, Руководство пользователя

Страница: 66 / 70

ECCO SG04LP1 | User Manual 66
7.2. Information for Commissioning the Inverter
After you have successfully powered up the inverter, it must be programmed and set up as per the program -
ming feature above.
Check each bond on the
solar panels Check the VOC does not
exceed 480V Ensure both MPPTs are
balanced
Measure the supply volt-
age check it matches the
settings of the inverter
If it falls out of the setting
range it will cause the
inverse shut down and
alarm
See Grid Setup page
Check the battery charge
and discharge is with-
in the C rating of the
battery. Too high will
damage the battery
Check the battery BMS is
communicating with the
inverter
This is the heart of the
system this controller
everything
Ensure you are familiar
with this, if you fully un
-
derstand the controller
you will fully appreciate
the capabilities of there
inverter
See section ‘Program
Charge / Discharge
Times’
This is for paralleling sys -
tems, and wind turbine
If paralleling inverters in
3 Phase check you phase
rotation before switch -
ing on the AC Load, in 3
Phase the output volt-
age will increase across
phase to 400V
If using a wind turbine
please ensure you have
the correct limiting resis-
tor, caps and rectifier
Familiarize yourself with
common fault codes