SunSetter Products, a Massachusetts Limited Partnership, 184 Charles Street, Malden, MA 02148
August 23, 2018
INS180-Gaviota_Upgrade_Instructions
Figure 9
Elbow
Position the LED Lights near the end of each Lateral Arm section, closest
to the Elbow. Refer to
Step 8.
Note
: This leaves enough slack in the Power Cable to allow the Lateral
Arms to close without damaging the Cables of the LED Light assembly.
View from underneath, looking up.
Attach the LED Light Strips
Working with your helper, position the LED Light on the Lateral Arm, beginning closest to the Elbow. See
Figure 9.
8. While your helper supports the other end of the LED Light, very carefully press the LED Light Assembly
onto the installed Mounting Clip closest to the Elbow until it clicks into place, then press onto the middle
Mounting Clip, then onto the Mounting Clip on the outer end. Repeat for the other mounting locations.
9. Connect the Low Voltage Cables from the Control Box to the LED Light Strips.
10. Plug in and test the LED Light System.
Attach the Mounting Clips
View from underneath, looking up.
Figure 8
Improperly Aligned
Mounting Clip
View from underneath, looking up.
View from underneath, looking up.
Figure 7
Properly Aligned
Mounting Clip
View from underneath, looking up.
Side view
cutaway
Lateral
Arm
LED
Light Strip
Clip
Push Straight Up
Onto Clip
6. Secure the Mounting Clips to the Lateral Arm using the supplied #8 x 1/4” Phillips screws. Make sure that
the Mounting Clips are aligned parallel to the Lateral Arms and the open channel faces down.
7.
See
Figure 7 for a PROPERLY aligned Clip and Figure 8 for an IMPROPERLY aligned Clip.
CAUTION
-Make sure that all of the Mounting Clips are still oriented parallel to the Lateral Arms before
completing the next step. LED Lights will not attach to improperly aligned Clips. Forcing LED Lights onto
improperly aligned Clips can permanently damage the Clips. See Figures 7 and 8.
