9
Center Punch and Drill the Holes for the LED Light Strip Mounting Clips
Figure 4
Front Bar
Connector
•
Always Drill underneath
the Lateral Arms.
• Do NOT Drill into the side
of the Lateral Arms.
• Stop Drilling as soon as
the Drill Bit cuts through
this outer wall.
Six (6) Inches
View from underneath, looking up.
Figure 5
Drilled Holes
Elbow
Six (6) Inches
Six (6) Inches
View from underneath, looking up.
Figure 6
Drilled Hole
Lateral Arm Clamp
Six (6) Inches
View from underneath, looking up.
4. Center-punch the marks (see locations in
Figure 2) that you made in Step 3. Note: Have your helper hold
the Lateral Arm steady while performing steps 4, 5 and 6 (punching, drilling holes and attaching clips).
WARNINGS:
• IN THE NEXT STEP, YOU MUST DRILL INTO THE LATERAL ARMS FROM UNDERNEATH, NOT FROM THE
SIDES. FAILURE TO DO SO CAN CAUSE DAMAGE TO THE LATERAL ARM.
• ALWAYS USE EYE PROTECTION WHEN OPERATING A DRILL.
• WHEN DRILLING, AS SOON AS THE DRILL BIT GOES THROUGH THE LATERAL ARM WALL, STOP
DRILLING. FAILURE TO STOP AS DESCRIBED CAN CAUSE DAMAGE TO THE LATERAL ARM AND THE
PROVIDED DRILL BIT.
5. Using the
provided Drill Bit, carefully drill a hole at each of the 12 marks. See Figures 4, 5 and 6.
Stop
drilling as soon as the Drill Bit cuts through the outer wall.
Use eye protection when operating a drill.
