8
Front Bar
Connector
Figure 2
Elbow
Lateral Arm Clamp
HOUSE
A
B
C
D
E
F
Note
: Measure and mark
in order of A, B, C, D, E, F
Section 1
Section 2
If your Awning has LED Lights
1. Extend the Awning to its fully open position. See Figure 2.
2. On Motorized Awnings, unplug the Power Cord on the Awning to prevent accidental movement of the
Awning during installation of the LED Lights.
3. Using a Tape Measure and Pencil, mark the Hole Locations to be drilled into the Lateral Arms for the
Mounting Clips, on the
UNDERSIDE of each Lateral Arm section (see Figure 2), inside the groove.
Section 1 Hole Locations
:
a. 6 inches from the Front Bar Connector, measuring toward the Elbow. See
Figure 4.
b. 6 inches from the Elbow, measuring toward the Front Bar Connector. See
Figure 5.
c. At the mid-point between points A and B.
Section 2 Hole Locations
:
d. 6 inches from the Elbow, measuring toward the Lateral Arm Clamp. See
Figure 5.
e. 6 inches from the Lateral Arm Clamp, measuring toward the Elbow. See
Figure 6.
f. At the mid-point between points D and E.
Note
: There will be a total of 6 hole locations on each Lateral Arm, or a total of 12 locations for both Lateral
Arms. See Figure 2.
Note
: All holes must be drilled in a straight line so LED Light Strips will snap on to the Mounting Clips.
