Z-Wave Frequency
Input Voltage
Output Voltage
908.42 MHz (US)
AC100-240V
AC100-240V
Resistive loads:4A
Capacitive/inductive loads:2A
0 to 40°C
8% to 80%
45.5x45x20.3mm
Product Data
Max. Load Current
Operating temperature
Relative humidity
Dimensions
The encryption mode that the curtain motor controller supports is S2 Unauthenticated. When the curtain
motor controller is being included into a Z-Wave network, you can use your primary controller/gateway to
enable encryption mode or disable encryption. (The primary controller/gateway shall support encryption
mode configuration). The curtain motor controller supports OTA and can update firmware wirelessly.
Main Features:
• Compatible with any Z-Wave or Z-Wave+ Controller,
• Controlled by Sunricher EasyHome or any other Z-Wave controller,
• Advanced microprocessor control
• Active element: electromagnetic, micro-gap relay switch
• The device may be operated by momentary or toggle switches, and by dedicated roller blind control
switches
• Connected motor's current and historical power consumption measured
• Over current protection
• To be installed in wall switch boxes of dimensions allowing for installation, conforming to provisions of
applicable regulations
• The curtain motor controller supports OTA and can update firmware wirelessly
Installation Guide
Please read carefully the enclosed user manual before installation of the curtain motor controller, in order
to ensure an error-free functioning.
ATTENTION:
Prior to the assembly of the product, the voltage network has to be switched OFF and
ensured against re-switching.
Inclusion (adding to a Z-Wave network)
1. Set primary controller/gateway into inclusion mode (Please refer to your primary controller’s manual on
how to turn your controller into inclusion).
2. Power on the curtain motor controller and set it into inclusion mode. There are two methods to set the
curtain motor controller into inclusion mode:
1)Triple press the network inclusion/exclusion button, it will set the curtain motor controller into inclusion
2
