23
Machine stops
Fuse has blown.
• Incorrect mains
voltage.
• Thermal sensor
activated.
• Nozzle partially
blocked.
• Replace fuse. Switch off
other machines using
the same circuit.
• Check that the mains
voltage corresponds to
specification on the
model tag.
• Leave the washer for 5
minutes to cool down.
• Clean the nozzle.
Fuse blows
Fuse too small.
• Install a fuse with a higher
amp rating than the amp
consumption of the
machine. Try the unit without
an extension cord.
Machine pulsating
• Air in inlet hose.
• Inadequate supply
of mains water.
• Nozzle partially
blocked.
• Water filter blocked.
• Hose kinked.
• Allow machine to run by
holding the trigger until
regular working pressure
resumes.
• Check that the water
supply corresponds to the
specifications required.
•
WARNING!
Avoid using
long, thin hoses (minimum
1/2 in. diameter).
• Clean the nozzle.
• Clean the water inlet filter.
• Straighten out the hose to
remove any kinks/blockages.
Machine often starts
and stops by itself
• Pump/spray gun is
leaking.
• Trigger mechanism
is broken.
• Please contact our
customer service
Machine starts, but
no water comes out
• Pump/hoses or
accessories frozen.
• No water supply.
• Water inlet filter
blocked.
• Nozzle blocked.
• Wait for pump/hoses or
accessories to thaw.
• Connect inlet water.
• Clean the water inlet filter.
• Clean the nozzle.
