9
HOW TO FILL AND EMPTY THE TANK
1.
Remove the
Fill Plug (No.33)
from the
Upper Tank Cover (No. 13)
.
2.
To fill the tank with water, refer to Fig.A. Insert the
Funnel (No. 77)
into the tank, then use a
cup or the
Siphon Pump (No. 76)
and a bucket to fill the tank. Use the water level gauge on
the side of the tank to measure desired water level in the tank.
3.
To empty the tank, refer to Fig. B. Place a bucket next to the rower, and use the
Siphon Pump
(No. 76)
to pump out the water from the tank into the bucket.
4.
Insert the
Fill Plug (No. 33)
into the
Upper Tank Cover (No. 13)
. Wipe excess water off of the
frame.
NOTE:
Fill the tank only with tap water. Add 1 water-purification tablet (1 packet is included.). Never
use pool chlorine or chlorine bleach. This will damage the tank and void the warranty.
Add a water purification tablet every 6 months or as needed. If water remains cloudy, replace
the water in the tank.
Do not consume the tank water. Dispose the water after pumping it out from the tank.
WATER LEVEL
See Fig. A. The water level gauge is on the side of the tank. The maximum fill level is 6.
Never fill it over this limit. Filling the tank over this limit will void the warranty.
The resistance depends on the water level in the tank. Water level 1 is the lowest resistance.
Level 6 is the highest resistance.
Water level label
