8
# 60 M8*15 4pcs
# 74 S5
# 71 OD20*ID8.5*1.5 4pcs
# 58 M8*15 4pcs
58
58
71 60
60 71
1
36
3
#74 S5
#71 OD20*ID8.5*1.5 2pcs
#75 S13-17
#56 M8 1pc
#63 M8*70 1pc
46
47
56
71
63 71
5
5
1
60
71
71
#60 M8*15 4pcs
#74 S5
#71 OD20*ID8.5*1.5 4pcs
ASSEMBLY INSTRUCTIONS
STEP 4:
NOTE:
Move the
Seat (No. 36)
to the front of the
Slide Rail (No. 3)
before assembly to prevent it
from gliding down during assembly.
Attach the
Slide Rail (No. 3)
to the
Main Frame
(No. 1)
using 4
Washers (No. 71)
, 4
Screws (No.
60)
and 4
Flat Screws (No. 58)
. Insert all 8
screws partially into the holes first, and then
tighten with
Allen Wrench (No. 74)
.
STEP 5:
Attach
Sensor Stand (No. 5)
to
Main Frame (No.
1)
using 4
Washers (No. 71)
and 4
Screws (No.
60)
. Tighten with
Allen wrench (No. 74)
.
If you are sitting on the Seat, the arrow sticker on
the
Sensor Stand (No. 5)
must be pointing
towards you. That means the
Sensor Stand (No.
5)
is installed in the correct direction.
STEP 6:
Connect 2
Sensor Wires (No. 47)
with the wires
of the
Meter (No. 46)
.
Attach the
Meter (No. 46)
to the
Sensor Stand
(No. 5)
using 1
Screw (No. 63)
, 2
Washers (No.
71)
and 1
Nylon Lock Nut (No. 56)
. Tighten with
Allen Wrench (No. 74)
and
Spanner (No. 75)
.
Make sure it is not too tight to adjust the angle of
Meter (No. 46)
.
The assembly is complete!
