SB--7--621
Page 24
16. Replace drive shaft grease seal (31) in the drive
end cover (29). The seal lip should always face to-
wards the bearing or lubricant. Pack bearing cavi-
ties with recommended grease and secure drive
cover with capscrews (30) to drive headplate.
Refer to FIGURE 25 for torque specifications.
Exercise care not to damage the seal
lip as it passes over the shaft keyway.
17. Assemble the gear cover (3) and gasket (7) to the
gear headplate (18) using capscrews (5). Tighten
the capscrews alternately and evenly. Refer to
FIGURE 25 for torque specifications.
18. Place the blower on its feet on a flat surface.
Loosen cap screws (16) and level the unit up. The
bench or blower base flatness should be within
.002 of an inch. Re--tighten cap screws (16) to the
specification in FIGURE 25.
If the unit is not flat within .002 of an
inch, it will be necessary to shim the
blower feet at installation.
GEAR DIAMETER
FASTENERS
2
3
4
5
CAPSCREW (21)
13 -- 17
23 -- 30
23 -- 30
23 -- 30
CAPSCREW (16)
13 -- 17
23 -- 30
23 -- 30
23 -- 30
SOCKET HD CAPSCREW (5)
6 -- 8
6 -- 8
13 -- 17
13 -- 17
SOCKET HD CAPSCREW (30)
6 -- 8
6 -- 8
13 -- 17
6 -- 8
CAPSCREW (10)
6 -- 8
6 -- 8
13 -- 17
13 -- 17
NOTE:
( ) DENOTES ITEMS IN EXPLODED VIEW DRAWINGS ON PAGES 25, 27, 29, AND 31.
FIGURE 25
-- TORQUE (FT--LBS)
Содержание Gardner Denver Sutorbilt Legend GAA P Series
