10
INSTALLATION INSTRUCTIONS (continued)
INSTALLING THE PLASTIC FAUCET LEVER
Attach the provided black plastic lever (pull handle) on
the top of the faucet tightening it by hand clockwise
until the end, holding in the silver snug underneath so
it does not move.
If there is a small drip from the faucet, you may have
tightened the plastic lever too much. Unscrew the
silver snug counter-clockwise one turn.
•
•
CONVERTING TO AN “ALL-REFRIGERATOR”
Turn the control knob to the “OFF” position.
Close the main valve on the CO
2
cylinder.
Close the secondary shut-off valve on the regulator pipe.
Close the connection between the beer keg and the keg coupler.
Drain any remaining beer from the lines.
Disconnect the beer line and CO
2
air line from the keg coupler.
Remove the beer keg.
Remove the keg coupler.
Disconnect the air line from the CO
2
cylinder.
Remove the CO
2
air line from cabinet plug.
Replace the air line rear cabinet plug.
Remove the beer tower and pull the beer line through the top of the cabinet.
Replace the top cabinet plug.
Order the optional wire shelves and install them on the side supports.
Adjust temperature as desired.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
REVERSING THE DOOR
Loosen and remove the three door hinge screws from the bottom hinge on the lower right base and
remove the hinge.
Remove the door and set aside.
Remove the plug from the top left corner of the door and place in top right of door.
Loosen and remove the two door hinge screws on the top right of the unit.
Place the top hinge on the left side of the unit front and, using the two previously removed screws,
tighten.
Remove the stopper from the bottom left side of the unit by removing the screw and replace on the
right side of the unit where the bottom hinge was previously removed.
Place door on top hinge of unit and replace the bottom hinge to the bottom left of the unit using the
three screws and tighten.
•
•
•
•
•
•
•
